While doing any of the above, listen for a casio wave ceptor 3749 user guide click that indicates that the lens barrel guide pins may have reseated in their guide slots.
Other variations include blowing with a hair dryer in no heat setting, or sucking the gaps with a vacuum (careful with this one).
If you get an Error E30, it means you don't have a memory card installed, so turn it off, slip in the memory card and turn it on one last time.
Then install new batteries, and turn on the camera.
I have many Canon's, and never use a case for this very reason.Thus extra battery power is available to the camera's lens motor during startup.If HP receives notice of such defects during the warranty period, HP will, at its option, either repair or replace products which prove to be defective.This digidoor ii instruction manual extra power can be useful in overcoming grit or sand particals that may be jamming the lens.If HP receives notice of such defects during the warranty period, HP will replace software which does not execute its programming instructions due to such defects.Inserting this cable ensures that the camera's LCD screen remains off during the start process.Fix #3: Insert the cameras Audio/Video (AV) cable, and turn the camera.Fortunately, about half the cameras that suffer this failure can easily be fixed by one of the following methods.However, there is also some potential for damaging or dislodging internal components with this method, such as unseating ribbon cables, or cracking LCD screens.This warranty gives you specific legal rights and you might also have other rights that vary from country to country, state to state, or province to province.
3HP does not warrant that the operation of HP products will be uninterrupted or error free.
The level of warranty service you receive may vary according to local standards.
Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera.
Who knows, you might get lucky.
Usually it's sand or grit interfering with the lens extension mechanism.Another variation includes looking for uneven gaps around the lens barrel, and then pushing on the side of the lens barrel that has the largest gap (note pushing the lens barrel all the way in is NOT recommended as it may become stuck there).HP will not alter form, fit or function of the product to make it operate in a country for which it was never intended to function for legal or regulatory reasons.Fix #5: Blow compressed air in the gaps around the lens barrels with the idea of blowing out any sand or grit that may be in there jamming the lens.Hewlett-Packardlimited warranty statement, hP product, duration of limited warranty, hP Photo Imaging Software 1 year for hardware 1 year telephone support (US and.
More people have reported success with this method than with any of the other methods.
Or the camera's been dropped with the lens extended.